VOLTCRAFT VC940 - V06-09 Provozní pokyny stáhnout pdf (Strana 45)

MultiSystem 4010

Operating Instructions

Rev. 1.5 / 120816 english

Page 45 of 45

7.2. Calibration • Maintenance • Repair

Attention

Possible loss of data!

The internal memory and the storage medium can be deleted during

calibration and repair. All measuring data and customer-specific

parameters will be lost irretrievably!

This device works maintenance-free. However it is essential to recalibrate it regularly. If the device is

in continuous use, we recommend a recalibration every 2 years. Hydrotechnik runs an efficient

calibration laboratory accredited by the DAkks, where measuring instrument and sensors (even from

third parties) can be checked and calibrated precisely.

In case of a repair you should contact our customer service department. It is very helpful if you have

the following information on hand. Please add this information in written to your instrument if you send

it to us:

• Complete address information (company, department, contact person, address, phone and fax

number, eMail address)

• Rejected part (instrument, sensor, cable, power pack)

• In the case of communication problems with your PC: used PC (CPU, RAM, HDD), operating

system (e.g. Windows 95/98/SE/2000/NT/XP/Vista/7, others), HYDROcom software version

• Fault description (leave the settings at the instrument like at the time of the error; describe your

measuring task, sensor connection, device settings: like e.g. recording parameters, trigger, number

of collected measured values, …)

Address of the Hydrotechnik Customer Support

Hydrotechnik GmbH

Holzheimer Straße 94-96 • D-65549 Limburg

Tel.: 06431 – 4004 0 • Fax: 06431 – 45308

E-Mail: info@hydrotechnik.com • Internet: www.hydrotechnik.com

1 2 ... 40 41 42 43 44 45

Žádné komentáře

VOLTCRAFT VC940 - V06-09 Provozní pokyny Strana 45