VOLTCRAFT VC940 - V06-09 Provozní pokyny stáhnout pdf (Strana 17)

MultiSystem 4010

Operating Instructions

Rev. 1.5 / 120816 english

Page 17 of 45

Signal type select the sensor output signal ("0/20 mA", "4/20 mA", "0/10 V", "2/10 V")

Measuring range enter beginning and end of the measuring range and confirm both entries

with

Zero point press

to execute the automatic zero point equalisation; assure that

the sensor has no load and press to run the equalisation; a possible

zero point deviation will be calculated in the software

Linearisation you may enter a calibration table for the connected sensor after setting

„Yes“ at the menu item „Linearisation“; please see the corresponding

section on page 23

5.6. Collect Measuring Data

Measured values are collected as measuring series that can be configured in the menu „Memory“.

Select function:

Select channels to be recorded:

Confirm selection:

Open recording functions:

Highlight setting:

or enter a value, e.g. 12.5:

Confirm setting or value:

Terminate programming:

Channels activate the channels that shall be recorded

Storing time decide how long measured values shall be recorded and choose the time units

Scan rate enter the intervals between two measurements and choose the time units

Information

Storing time and scan rate define, how long and often values are

recorded. It is recommended to keep the amount of recorded measuring

data as small as possible to ease the later evaluation and presentation.

Trigger event a trigger is a condition that must happen before a recording may start or end; here

“p1” is defined, that means the recording will start if the p1-value exceeds 200.

Please see section 6.6 on page 33 for information on the use of triggers.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 44 45

Žádné komentáře

VOLTCRAFT VC940 - V06-09 Provozní pokyny Strana 17