VOLTCRAFT VC940 - V06-09 Provozní pokyny stáhnout pdf (Strana 32)

MultiSystem 4010

Operating Instructions

Rev. 1.5 / 120816 english

Page 32 of 45

Highlight a channel and press

to display / hide it. All channels with a green

check mark will be displayed. Press

to confirm the channel selection.

Display rate define how often the display shall be refreshed with new measured values; this

settings does not influence the scan rate, that means those time intervals after that

new measured values are requested from the sensor

Contrast controls the brightness of the display

Presentation select whether the measured values shall be displayed as text or line diagram

(„Graphic“); if you select „Text“ you may select the color of the measured values in

the line below; if “Graphic” is selected, further settings will be displayed:

Scaling defines which part of the measuring range of each channel will be displayed:

Press

to toggle between the input modes „User“ (manual input of scaling

values) and „Auto“.

USER highlight a channel, press

and enter the lower limit of the desired display

range; press

, enter the upper limit and confirm with ; repeat that for all

desired channels

AUTO press

to define the scaling range for the highlighted channel automatically, or

to do this for all channels; the sensor measuring ranges will be used as scaling

ranges

Confirm the scaling with

Colors/Symbols here you may select the colors and symbols used to distinguish the channels in the

line diagram:

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 44 45

Žádné komentáře

VOLTCRAFT VC940 - V06-09 Provozní pokyny Strana 32