VOLTCRAFT VC940 - V06-09 Provozní pokyny stáhnout pdf (Strana 26)

MultiSystem 4010

Operating Instructions

Rev. 1.5 / 120816 english

Page 26 of 45

Manual the output can be switched using the parameter „Condition“

If „Meas. channel“ is selected, further parameters will be displayed:

Source select the measuring channel that shall be supervised for the incident that

shall switch the output

Condition select either „greater“ or „lower“; the output will be switched if the value at

the selected channel exceeds / falls below the defined value

Value enter the value for the condition

In the image channel p1 is supervised, the output will be switched if the measured value exceeds 120.

Simultaneous recording on connected instruments

You need a special cable (order N

8824-F2-00.50) to connect two MultiSystem 4010, or the

MultiXtend Trigger (order N

316A-A0-00.50) to connect up to five instruments. Then it becomes

possible to start build up a master-slave connection and start a recording on all instruments

simultaneously.

At the Master Instrument you should program a recording that is started by a trigger event. Then

select “Trigger event” as operation mode of the trigger output. As soon as the trigger event happens,

the output will be switched.

At the Slave Instruments you should program a recording that is started by the trigger event

„Channel E1 – ON”. Then the recording will be started as soon as the trigger input receives the signal

from the trigger output of the master instrument.

More information on the setup of trigger recordings is contained in section 6.6 on page 33.

6.4.6. Free channels (C8 … C12)

These channels can be used for calculations or as CAN channels (option).

Press

and select one of the available occupations:

UNDEF. channel is not used

Ch1-Ch2 calculation of the difference of the measured values from channel 1 and 2

Ch3-Ch4 calculation of the difference of the measured values from channel 3 and 4

Ch4-Ch5 calculation of the difference of the measured values from channel 4 and 5

Ch1/dt calculates the first derivation of the measured values from channel 1

Ch5/dt calculates the first derivation of the measured values from channel 5

POWER uses the formula „Ch1 x Ch5 / 600“ to calculate the hydraulic power; pressure is

measured on channel 1, volume flow rate on channel 5

CAN a signal from a connected CAN bus (option) is assigned to the channel

Multimeter the signal from a Multimeter connected to the instrument is assigned to this

channel

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 44 45

Žádné komentáře

VOLTCRAFT VC940 - V06-09 Provozní pokyny Strana 26